The StayK General Information

STAYK^Ž Installation:

1. Check for buried utilities before using. Remove all debris (limbs, Spanish moss, tall weeds or grass, etc.). Make positively sure the animal cannot travel around trees, bushes, poles, or any other objects protruding from the ground.

2. Use a common hammer (2lb. recommended); install by hammering the top of the anchor shaft/center rod until the lower reference washer is ground level. Check that the rotation block and sleeve turn/rotate effortlessly.

3. Connect desired leash/lead to the rotation block using the supplied u-bolt and fasteners. Do not substitute hardware.

4. Do Not leave pets or animals unattended. Make sure sufficient food and water are placed within reach on the outer radius of animals travel to prevent tipping of water and/or food containers.

5. Removal: To remove the STAYK^Ž from the ground, simply tap/hammer on the side of the rotation block or sleeve to loosen the soil around the anchor shaft and pull straight up on the rotation block. If the removal seems too difficult or the individual has medical reasons why they/you should not be performing/attempting the removal process, do not proceed. Find an individual who can remove the STAYK^Ž from the ground safely.

Note: It is recommended to have a swivel located at one or both ends of the tether. Never leave any pet or animal unattended or without food and water.

Ground Sleeve Installation for the STAYK^Ž:

1. Check for buried utilities before using.

2. Install the STAYK^Ž in the desired location following the installation instructions. Once the tether is in position, remove the STAYK^Ž and place the supplied extra washer over the anchor shaft followed by the Ground Sleeve.

3. Drive the Ground Sleeve and tether into position using the same guidelines as in the installation instructions.

4. Once the tether is into position, remove the tether and remove the extra washer from around the anchor shaft.

5. Reinstall the tether into the Ground Sleeve and your ready. Always make sure the lower reference washer is at ground level and that the leash or lead used will not travel under the lower washer in order to prevent the possibility of tangling.

Disclaimer: Use Product at your own risk. StayK Industries, Inc. and/or Creative Designs and/or any business or person affiliated shall not be liable for the loss of use of the product, products, inconvenience, loss or any other damages, whether direct, incidental or consequential.